水穩基層施工工藝流程

　　Construction process of water stable base layer

　　養生、交通管制、層間處理及其他

　　Health preservation, traffic control, interlayer treatment, and others

　　1、無機結合料穩定材料層突出完成并經壓實度檢查合格后，應及時養生。

　　1. After the stable material layer of inorganic binder is compacted and passes the compaction degree inspection, it should be cured in a timely manner.

　　2、無機結合料穩定材料的養生期宜不少于7d，養生期宜延長至上層結構開始施工的前2d，當非常高 氣溫低于10℃時，應適當延長養生時間。

　　2. The curing period of inorganic binder stabilized materials should not be less than 7 days, and the curing period should be extended to the first 2 days before the construction of the upper structure. When the highest temperature is below 10 ℃, the curing time should be appropriately extended.

　　3、養生可采取土工布覆蓋養生、撒鋪乳化瀝青養生等方式，宜結合工程實際情況選擇適宜的方式。 7.1.4 無機結合穩定材料層過冬時應采取必要的保護措施。

　　3. Health preservation can be achieved by covering with geotextile or spreading emulsified asphalt. It is advisable to choose the appropriate method based on the actual situation of the project. 7.1.4 Necessary protective measures should be taken for the inorganic bonding stable material layer during winter.

　　4、根據結構層位的不同和施工工序的要求，應擇機進行層間處理。

　　4. According to the different structural layers and the requirements of the construction process, interlayer treatment should be carried out at the appropriate time.

　　5、養生方式

　　5. Health Preservation Methods

　　土工布養生應符合下列規定：

　　Geotextile curing should comply with the following regulations:

　　a) 宜采用透水式土工布全斷面覆蓋，也可鋪設防水土工布；

　　a) It is advisable to use permeable geotextile to cover the entire cross-section, or to lay waterproof geotextile;

　　b) 鋪設過程中應注意縫之間的搭接，不應留有間隙；

　　b) During the laying process, attention should be paid to the overlap between joints and no gaps should be left;

　　c) 鋪設土工布后，應注意灑水，每天灑水次數應視氣候而定。夏天施工時，上、下午宜各灑水 一次；

　　c) After laying the geotextile, attention should be paid to watering, and the frequency of watering per day should depend on the climate. During summer construction, it is advisable to sprinkle water once in the morning and once in the afternoon;

　　d) 養生至上層結構層施工前1～2d，方可將土工布掀開；

　　d) The geotextile can only be lifted 1-2 days before the construction of the upper structural layer for health preservation;

　　e) 在養生過程中應采取有效措施防止土工布的破損。

　　e) Effective measures should be taken during the process of health preservation to prevent damage to the geotextile.

　　6、對瀝青面層厚度大于20cm的結構，可采用乳化瀝青方式養生，并應符合下列規定：

　　6. For structures with an asphalt surface layer thickness greater than 20cm, emulsified asphalt can be used for curing, and the following regulations should be met:

　　a) 應在突出完成后立即灑布透層乳化瀝青進行養生；

　　a) After the compaction is completed, the prime coat emulsified asphalt should be sprayed immediately for curing;

　　b) 控制在終凝時間內噴灑透層油的滲透效果非常佳；

　　b) The best penetration effect is achieved by spraying the penetrating oil within the final setting time;

　　c) 透層乳化瀝青采用瀝青灑布車施工，灑布時車速及噴灑量應保持穩定，建議透層灑布量為 0.8～1.0L/m2，具體灑布量根據試灑確定；

　　c) The emulsified asphalt for the prime coat is constructed using an asphalt spraying truck, and the speed and spraying amount should be kept stable during spraying. It is recommended to use a prime coat spraying amount of 0.8-1.0L/m2, and the specific spraying amount should be determined based on trial spraying;

　　d) 灑布透層前，路面應清掃干凈，遮擋防護路緣石及人工構造物避免污染；

　　d) Before applying the penetrating layer, the road surface should be cleaned thoroughly, and protective curbs and artificial structures should be covered to avoid pollution;

　　e) 乳化瀝青應透入基層足夠深度，并不得形成表面徑流；

　　e) Emulsified asphalt should penetrate deep enough into the base layer and not form surface runoff;

　　f) 氣溫低于 10℃時，不得灑布透層瀝青，當遇大風或降雨時，不得灑布透層瀝青； g) 應按設計瀝青用量一次灑布均勻，當有遺漏時，應進行人工補灑；

　　f) When the temperature is below 10 ℃, it is not allowed to sprinkle the prime coat asphalt. When encountering strong winds or rainfall, it is not allowed to sprinkle the prime coat asphalt; g) The asphalt should be evenly sprayed at once according to the designed amount. If there are omissions, manual replenishment should be carried out;

　　h) 對于側面的養生，在拆除側模后，用塑料薄膜進行覆蓋養生，塑料薄膜覆蓋嚴密保證不透氣， 保持內部水分不損失或者噴灑透層油進行養生。

　　h) For the side health preservation, after removing the side mold, cover it with plastic film for health preservation. The plastic film should be tightly covered to ensure that it is not breathable, and the internal moisture should not be lost or sprayed with a transparent layer of oil for health preservation.

　　7、 透層乳化瀝青宜采用 PA-2 型陰離子或 PC-2 噴灑型陽離子乳化瀝青，優先選用陰離子型乳化瀝青。

　　7. PA-2 type anionic or PC-2 spray type cationic emulsified asphalt should be used for the permeable layer emulsified asphalt, and anionic emulsified asphalt should be preferred.

　　交通管制

　　traffic control

　　1、正式施工前宜建好施工便道。對于高速公路和一級公路，無施工便道，不應施工。

　　1. It is advisable to build construction access roads before formal construction. For expressways and first-class highway, construction should not be carried out without access roads.

　　2、水泥穩定碎石基層養生期間應封閉交通，除灑水車和小型通勤車輛外嚴禁其他車輛通行，小型 車輛和灑水車的行駛速度應小于40km/h。 水泥穩定碎石材料層之間的處理

　　2. During the maintenance period of cement stabilized crushed stone base, traffic should be closed off, and other vehicles are strictly prohibited from passing except for sprinkler trucks and small commuting vehicles. The driving speed of small vehicles and sprinkler trucks should be less than 40km/h. Treatment between cement stabilized crushed stone material layers

　　3、在上層結構施工前，應采用人工、小型清掃車以及灑水沖刷的方式將下層表面的浮漿清理干凈。 下承層局部存在松散現象時，也應有效清理干凈。

　　3. Before the construction of the upper structure, manual labor, small cleaning vehicles, and water spraying should be used to clean the floating slurry on the lower surface. When there is looseness in the lower layer, it should also be thoroughly cleaned.

　　4、下承層清理后應封閉交通。在上層施工前1～2h，宜灑水使下承層進行保持濕潤狀態。

　　4. After cleaning the lower layer, traffic should be closed off. 1-2 hours before the upper layer construction, it is advisable to sprinkle water to keep the lower layer moist.

　　5、可采用上下結構層連續攤鋪施工的方式，每層施工應配備獨立的攤鋪和突出設備，不得采用一 套設備在上下結構層來回施工。在瀝青面層施工前1～2d內，應清理基層頂面。

　　5. The construction method of continuous paving of upper and lower structural layers can be adopted, and each layer of construction should be equipped with independent paving and rolling equipment. It is not allowed to use a set of equipment to construct back and forth between the upper and lower structural layers. Within 1-2 days before the construction of the asphalt surface layer, the top surface of the base layer should be cleaned.

　　本文由 濟南水穩料  友情奉獻.更多有關的知識請點擊  http://m.huatts.com/   真誠的態度.為您提供為多維度的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

　　This article is contributed by Jinan Water Stable Material Friendship For more related knowledge, please click http://m.huatts.com/ Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.