公司新聞
選瀝青混凝土要看性質及制備工藝
來源：http://m.huatts.com/ 日期：2022-11-30
瀝青混凝土按所用集料品種不同，可分為碎石的、礫石的、砂質的、礦渣的數類，以碎石采用為普遍。那你知道選濟南瀝青混凝土要看什么嗎？
According to different types of aggregates used, asphalt concrete can be divided into crushed stone, gravel, sandy and slag, and crushed stone is widely used. Do you know what to look for when choosing Jinan asphalt concrete?
性質
nature
瀝青混凝土材料的強度主要表現在兩個方面。一是瀝青與礦粉形成的膠結料的粘結力;另一是集料顆粒間的內摩阻力和鎖結力。礦粉細顆粒(大多小于0.075毫米)的巨大表面積使瀝青材料形成薄膜，從而提高了瀝青材料的粘結強度和溫度穩定性;而鎖結力則主要在粗集料顆粒之間產生。
The strength of asphalt concrete materials is mainly shown in two aspects. One is the cohesive force of the binder formed by asphalt and mineral powder; The other is the internal friction and locking force between aggregate particles. The huge surface area of fine mineral powder particles (mostly less than 0.075mm) makes asphalt material form a film, thus improving the adhesive strength and temperature stability of asphalt material; The locking force is mainly generated between coarse aggregate particles.
選擇瀝青混凝土礦料級配時要兼顧兩者，以達到加入適量瀝青后混合料能形成密實、穩定、粗糙度適宜、經久耐用的路面。配合礦料有多種方法，可以用公式計算，也可以憑經驗規定級配范圍。瀝青混凝土材料中的瀝青適宜用量，應以試驗室試驗結果和工地實用情況來確定，一般在有關規范內均列有可資參考的瀝青用量范圍作為試配的指導。
The mineral aggregate gradation of asphalt concrete shall be selected in consideration of both, so that the mixture can form a dense, stable, suitable roughness and durable pavement after adding an appropriate amount of asphalt. There are many methods for mixed mineral aggregate, which can be calculated by formula or the grading range can be specified by experience. The appropriate amount of asphalt in asphalt concrete materials shall be determined based on the laboratory test results and the practical situation of the construction site. Generally, the range of asphalt amount that can be referenced is listed in the relevant specifications as the guide for trial mixing.
制備工藝
Preparation process
熱拌的瀝青混凝土材料宜在集中地點用機械拌制。一般選用固定式熱拌廠，在線路較長時宜選用移動式熱拌機。冷拌的瀝青混凝土材料可以集中拌和，也可就地路拌。
Hot mixed asphalt concrete materials should be mixed mechanically at centralized locations. Generally, fixed hot mixing plants are selected, and mobile hot mixing machines should be selected when the line is long. Cold mixed asphalt concrete materials can be mixed in a centralized way or mixed on the road.
在制備工藝上，過去多采用先將砂石料烘干加熱后，再與熱瀝青和冷的礦粉拌和。又發展一種先用熱瀝青拌好濕集料，然后再加熱拌勻的方法，以消除因集料在加熱和烘干時飛灰。
In terms of preparation technology, in the past, the sand and gravel materials were dried and heated before being mixed with hot asphalt and cold mineral powder. A method of mixing wet aggregate with hot asphalt first, and then heating and mixing is developed to eliminate fly ash caused by heating and drying of aggregate.
采用后一種工藝時，要防止殘留在混合料中的水分影響瀝青混凝土使用壽命，好能同時采用瀝青抗剝落劑，以增強抗水能力。
When using the latter process, it is necessary to prevent the residual moisture in the mixture from affecting the service life of asphalt concrete, so that asphalt anti stripping agent can be used at the same time to enhance the water resistance.
以上就是關于選瀝青混凝土要看性質及制備工藝問題的相關解答了，您對此有什么不理解的地方可以隨時來我們網站http://m.huatts.com進行咨詢，為您講解更多事項！
The above is the answer to the question that the selection of asphalt concrete depends on its properties and preparation process. If you have any questions about this, you can come to our website at any time http://m.huatts.com Consult and explain more matters to you!
公司地址：濟南市商河縣賈莊鎮民營經濟創業園
公司名稱:永誠廣建公路材料（山東）有限公司 
備案號：